Forum Thread: WPS Pin

WPS Pin

Hi all, im new to this. I've read quite a lot of information on cracking the WPS pin and i succeed to get the pin. My question may be stupid. But what do i have to do to actually connect to the wireless network using te WPS pin?

Thanks!!

6 Responses

The -p option in reaver can be used to try a known pin. How did you get the pin?

thanks for the reply. I've used fern-wifi-cracker to get the pin. How can i turn the pin to a WPA2 key? or how do i connect only using the pin? is that possible?

Using reaver with -p will show you the key. I don't know of any other way.

Thank you! what command do i have to use? (the WPS pin)-p? Like: 12345678 -p? is that enough?

The -p is a reaver flag. So if you're using kali, first enable monitor mode on wiour wifi with
airmon-ng start wlan0
then
reaver -i mon0 -b xx:xx:xx:xx:xx:xx -p 12345678 -vv

where -b is mac address of target router.

Sometimes when you connect to a WPS enabled router, you are asked either for a pass, or for a pin, that's depending on OS/phone.

Thank you very much guys!! it worked!

Share Your Thoughts

  • Hot
  • Active